...
The installation scripts shown here installs all the required components.It is
installed by default with the configuration which refer to other components. ACM components should be configured with couple of other components for the participants to work.
In case some of the installation is already setup or not set by the installation scripts, Below environment variables can be used to set the configurations for the ACM through installation scripts.
Tip |
---|
Ignore the below variables if the entire environment is being setup by the installation scripts below |
Variable Name | Description | Default Value |
---|
A1PMS_HOST |
---|
Address of the A1PMS. It will be accessed from A1PMS participant. | http://policymanagementservice.nonrtric:9080 |
---|---|
CHART_REPO_HOST |
Address of the chart repository. It will be used by Kubernetes participant. | http://IP_ADDRESS:8879/charts IP_ADDRESS: IP of the host in which the installation scripts are running. |
---|
Installation
All components can be installed using the command below,
...
- If Kserve installation failed or end up in the below state after "install-all.sh", Try run "installpatch-kserve.sh" script after "install-all.sh"
...